Materials Science

Bradt, R. C., D. P. H. Hasselman, and F. F. Lange, editors. Fracture Mechanics of Ceramics. Volume 1: Concepts, Flaws, and Fractography. New York: Plenum Press, 1974. 1st printing. xiii, 443, xv-xxviii pages. Index. Bibliographical references. Illustrations. First half of the proceedings of a symposium on the Fracture Mechanics of Ceramics, held at Pennsylvania State University, University Park, Pennsylvania, July 11-13, 1973. Good hardcover. Exlibrary: spine label, stamps on top, fore and bottom edges, stamp and review label inside front cover, stamp on Preface page; barcode label inside rear cover. Bookplate removed from front flyleaf, leaving small hole in center. Small colored felt-tip mark on top edge. ISBN 0306375915. #24978. $35
Place an Order or Ask a Question ~ Ordering Information

Fillard, J. P., editor. Defect Recognition and Image Processing in III-V Compounds. Proceedings of the International Symposium on Defect Recognition and Image Processing in III-V Compounds (DRIP 1985), Montpellier, France, July 2-4, 1985. Amsterdam: Elsevier, 1985. xii, 306 pages. Index. Illustrations. Materials Science Monographs, 31. Good hardcover. ISBN 0444425586. #19861. $50
Place an Order or Ask a Question ~ Ordering Information

Jena, P., and C. B. Satterthwaite, editors. Electronic Structure and Properties of Hydrogen in Metals. New York: Plenum Press, Published in cooperation with NATO Scientific Affairs Division, 1983. 1st printing. xv, 698 pages. Index. Bibliographical references. Illustrations. NATO Conference Series. VI: Materials Science, Volume 6. Proceedings of a NATO International Symposium on the Electronic Structure and Properties of Hydrogen in Metals, Held March 4-6, 1982, in Richmond, Virginia. Good hardcover. Exlibrary: spine label, stamps on top, fore and bottom edges, stamp inside front cover; barcode label and stamp inside rear cover. ISBN 030641130X. #25996. $90
Place an Order or Ask a Question ~ Ordering Information

Kaufman, Larry, and Harold Bernstein. Computer Calculation of Phase Diagrams. With Special Reference to Refractory Metals. New York: Academic Press, 1970. xi, 334 pages. Index. Illustrations. Refractory Materials, A Series of Monographs, Volume 4. Good hardcover. Exlibrary: spine label, stamps on top, fore and bottom edges, stamp inside front cover, stamp on rear flyleaf, barcode label inside rear cover; some underlining. #25995. $155
Place an Order or Ask a Question ~ Ordering Information

Kettunen, P. O., T. K. Lepisto, and M. E. Lehtonen, editors. Strength of Metal Alloys. Proceedings of the 8th International Conference on the Strength of Metals and Alloys, Tampere, Finland, 22-26 August 1988. ICSMA 8. Volume 2. Oxford: Pergamon Press, 1989. xxiv, pages 507-1036. Illustrations. Very good hardcover. ISBN 0080348041. #19904. $65
Place an Order or Ask a Question ~ Ordering Information

Klein, Lisa C., editor. Sol-Gel Technology for Thin Films, Fibers, Preforms, Electronics and Speciality Shapes. Park Ridge, New Jersey: Noyes Publications, 1988. 4th printing. xxi, 407 pages. Index. Illustrations. Materials Science and Process Technology Series. Subjects include ceramic materials, glass fiber, thin films, colloids. Very good hardcover in very good dust jacket. Small colored felt-tip mark on top edge. ISBN 081551154X. #25042. $175
Place an Order or Ask a Question ~ Ordering Information

Koenig, C. J. Influence of Grain-Size Distribution and Fluid-Energy Reduction on the Properties of Lakefield Nepheline Syenite. Columbus: College of Engineering, Ohio State University, 1955. 1st printing. iii, 29 pages. Illustrations. Ohio State University Studies, Engineering Series, Volume XXIV, no. 2, May, 1955. Engineering Experiment Station Bulletin, no. 156. Investigation in cooperation with Great Lakes Foundry Sand Company and American Nepheline, Ltd. Good stiff wrappers (soft cover). Compliments stamp on front cover and title page. #24647. $20
Place an Order or Ask a Question ~ Ordering Information

Koenig, C. J. Nepheline Syenite in Ceramic Wares. Preface by G. A. Bole. Columbus: College of Engineering, Ohio State University, 1940. 2d printing. v, 74 pages. Illustrations. Ohio State University Studies, Engineering Series, Volume VIII, no. 6, November, 1939. Engineering Experiment Station Bulletin, no. 103. Investigation in cooperation with Great Lakes Foundry Sand Company and American Nepheline Corporation. Good stiff wrappers (soft cover). Compliments stamp on front cover and title page. #24648. $20
Place an Order or Ask a Question ~ Ordering Information

Koenig, C. J. Nepheline Syenite in Low-Temperature Vitreous Wares. Preface by George A. Bole. Columbus: College of Engineering, Ohio State University, 1942. iv, 36 pages. Illustrations. Ohio State University Studies, Engineering Series, Volume XI, no. 4, July, 1942. Engineering Experiment Station Bulletin, no. 112. Investigation in cooperation with Great Lakes Foundry Sand Company and American Nepheline Corporation, Edgar Plastic Kaolin Company. Good stiff wrappers (soft cover). #24649. $30
Place an Order or Ask a Question ~ Ordering Information

McNamara, Edward P. Ceramics. Volumes I & II: Introduction to Ceramics. Volume III: Clay Products and Whitewares. (3 volumes). Foreword by Edward Steidle (v. 1-3). Foreword by H. B. Northrup (v. 1). Foreword by D. C. Jones (v. 2-3). State College: Pennsylvania State College, Division of Mineral Industries Extension, School of Mineral Industries, 1946, 1948. 3 volumes (ix, 376; vi, 350; vii, 336 pages). Bibliographical references. Photographs. Illustrations. Very good hardcover books. Some foxing in volumes 2 and 3. #24200. $80
Place an Order or Ask a Question ~ Ordering Information

Manos, Dennis M., and Daniel L. Flamm, editors. Plasma Etching: An Introduction. San Diego: Academic Press, 1989. 1st printing. xii, 476 pages. Index. Bibliographical references. Illustrations. Plasma-Materials Interactions. Good hardcover. Exlibrary: spine label, stamps on top, fore and bottom edges, stamp inside front cover; barcode label on rear flyleaf. ISBN 0124693709. #25969. $60
Place an Order or Ask a Question ~ Ordering Information

Storms, Edmund K. The Refractory Carbides. New York: Academic Press, 1967. 1st printing. xiii, 285 pages. Index. Bibliography. Photographs. Illustrations. Refractory Materials, A Series of Monographs, Volume 2. Good hardcover. Exlibrary: spine label, stamps on top, fore and bottom edges, stamp inside front cover; barcode label on rear flyleaf. #25994. $145
Place an Order or Ask a Question ~ Ordering Information

Taya, Minoru, and Richard J. Arsenault. Metal Matrix Composites: Thermomechanical Behavior. Oxford: Pergamon Press, 1989. 1st edition. ix, 264 pages. Index. Illustrations. Good hardcover. Upper spine slightly crushed and wrinkled. ISBN 0080369847. #19903. $65
Place an Order or Ask a Question ~ Ordering Information

Whitaker, L. R. The Design and Correction of Dies. Chicago: Industrial Publications / Brick & Clay Record, 1947. 58 pages. Photographs. Illustrations. Reprinted from 1945-1946 Issues of Brick and Clay Record. 'The author's entire ceramic experience has been in the clay products industry, and with his practical plant background he is fully qualified to discuss auger operation.' - Profile. Very good hardcover. #24199. $40
Place an Order or Ask a Question ~ Ordering Information

Zheludev, I. S. Physics of Crystalline Dielectrics. Volume 1: Crystallography and Spontaneous Polarization. Volume 2: Electrical Properties. Translated from Russian by Albin Tybulewicz. New York: Plenum Press, 1971. 1st printing. 2 volumes. 620 pages total, including a folding plate in each volume. Index. Bibliographical references. Illustrations. Volume 2 ISBN 0306377829. Good hardcover books. Exlibrary: spine labels, stamps on top, fore and bottom edges, stamps inside front cover, on prefaces pages; barcode labels and stamps on rear flyleaf. Small colored felt-tip marks on top edge. ISBN 0306377810. #24892. $200
Place an Order or Ask a Question ~ Ordering Information